F 150 Super Crew 4WD V8-4.6L SOHC VIN 6 (2003)
16. CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools
cause scratches and gouges which make leak paths. Use a plastic scraping tool to remove all traces of old sealant.
NOTE: The bolts are part of the valve cover and cannot be removed.
NOTE: Windsor engine shown; Romeo engine similar.
Remove the RH valve cover.
-
Fully loosen the bolts and remove the valve cover.
-
Clean the valve cover mating surface of the cylinder head with silicone gasket remover and metal surface prep. Follow the directions on the
packaging.
-
Inspect the valve cover gasket. If the gasket is damaged, remove and discard the valve cover gasket. Clean the valve cover gasket groove with
soap and water or a suitable solvent.
Installation
All vehicles
1. If a new gasket is being installed, apply instant adhesive completely around the gasket groove in the valve cover. Install the new valve cover
gasket.
