F 150 Super Crew 4WD V8-4.6L SOHC VIN 6 (2003)
1. Pull the front parking brake cable and conduit.
2. Insert a suitable retainer pin.
2. Raise and support vehicle.
3. Remove the wheel and tire assembly.
4. CAUTION: Use of a brake drum puller or a torch is not recommended. Brake drum distortion may result.
NOTE: If the brake drum its rusted tin the axle shaft flame, tap the center of the brake daub .
Remove the brake drum.
5. NOTE: If the brake drum will not come off, follow these steps.
Loosen the brake adjuster screw.
1. Disengage the brake shoe adjusting lever from the brake adjuster screw.
2. Use a brake adjustment too] to loosen the brake adjuster screw. the brake drum inside diameter. Install a new brake drum if it exceeds
maximum inside diameter.
6. Use a brake drum micrometer to measure
Installation
WARNING: Incorrectly tightened wheel nuts could allow the wheel to come off while the vehicle is in motion causing loss of control.
1. If adjusting the rear brakes With brake dating removed, refer to Brake Shoe Adjustment.