F 150 Super Crew 4WD V8-4.6L SOHC VIN 6 (2003)
^
Measure from the stub shaft weld to the U-joint centerline.
4
Bleed the air from the slip-yoke boot.
9. Using the special tool, crimp the large driveshaft slip-yoke boot clamp.
10. install the driveshaft.
11. NOTE: If a vibration exists, insert 1.59-mm (1/16-inch) shims, as necessary, between the driveshaft center bearing bracket and support plate (on
the bolt ends of the driveshaft center bearing bracket) to reduce compression of the rubber insulator.
Road test the vehicle.
