F 150 Super Crew 4WD V8-5.4L Prop SOHC VIN Z (2003)
INSTALLATION
1. To install, reverse the removal procedure.
NOTE:
^
Make sure that safety belt webbing is not twisted prior to installation. The SuperCab rear retractor anchor should be positioned with the
vertical leg facing outboard.
^
Apply Ford Threadlock 262 (E2FZ-19554-B) or equivalent to fasteners when installing safety belt buckle or retractor assemblies.
2. Check the restraint system for correct operation.
Center
REMOVAL INSTALLATION
1. Disassemble the rear seat cushion and remove the safety belt buckle. See: Safety Belt
Outboard
SPECIAL TOOL(S)
REMOVAL
NOTE: New safety belt buckles, height adjusters, center adjust tongues, and belts and retractors can be installed separately. However, if a safety belt
assembly was in use during a collision, a new belt and retractor must be installed as well as the center adjust tongue, and belt and buckle assembly or the
center adjust tongue, and the cable and buckle assembly. When installing new safety belts and buckles, height adjusters, safety cables and buckles, center
adjust tongues, and belts and retractors, use only the parts specified in the Ford Master Parts Catalogs for the make and model of the vehicle being
repaired. Safety belt assemblies must not be interchanged between vehicle models.
NOTE: The passenger side is shown. The driver side is similar.
1. Remove the C-pillar trim panel.
