F 150 Super Crew 4WD V8-5.4L Prop SOHC VIN Z (2003)
Seat Belt Height Adjuster: Service and Repair
General Procedures
D-Ring Installation Kit
SPECIAL TOOL(S)
1. Remove the upper corner trim panels.
2. Use the half-inch drill with integral stop provided in D-Ring Installation Kit 100-F012 (134-00018) or equivalent to drill out the damaged threads
in the upper B-pillar structure.
3. Apply a suitable lubricant to the M14x1.5 tap with integral stop provided in D-Ring Installation Kit 100-F012 (134-00018) and tap new threads.
NOTE: After each rotation, back tap off slightly to remove new cuttings and be sure to clean out any chips before proceeding.
4. Use a threaded insert (N807170-S190) provided in D-Ring Installation Kit 100-F012 (134-00018) or equivalent and screw it into the retapped hole
until it is slightly below the surface of the hole.