F 250 2WD HD Pickup V8-7.3L DSL Turbo VIN F (1997)
CAUTION: Cork gaskets and elastomeric gaskets are net interchangeable. If you remove a cork gasket, replace it with a cork gasket. If you
remove an elastomeric gasket, clean, inspect and reuse unless gasket is damaged. Be careful not to cut or bend elastomeric gasket.
6. Remove filter assembly and seal by carefully pulling and rotating filter as necessary. Discard filter assembly and seal.
NOTE: Seal might remain in bore when filter assembly is removed.
7. If seal remains in bore, carefully remove using a screwdriver.
CAUTION: Use care not to scratch or damage aluminum pump bore.
8. Remove manual lever shaft retaining pin using Lock Nut Pin Remover T78P-3504-N.
