F 250 2WD LD Pickup V8-4.6L SOHC VIN 6 (1997)
Function Tests
14. Select FUNCTION TESTS and press trigger to start the NGS.
Service Bleed Function
15. Select SERVICE BLEED FUNCTION and press trigger to start the NGS.
Service Bleed Function
16. Select PRESS TRIGGER TO BEGIN.
NOTE: The brake pedal should be depressed while this procedure is functioning. Perform at least five service bleed procedures.
17. Repeat conventional bleed procedure as outlined in steps 1 through 4.
18. If brake pedal feels spongy, repeat NGS service bleed procedure as outlined in steps 5 through 16 and repeat conventional bleed steps 1 through 4.
Gravity Bleeding
-
Fill the brake master cylinder reservoir with High Performance DOT 3 Brake Fluid C6AZ-19542-AB or DOT 3 equivalent meeting Ford
specification ESA-M6C25-A, DOT 3.
-
Loosen both wheel cylinder bleeder screws and leave open until clear, bubble-free brake fluid flows. Be sure to check the brake fluid level in the
brake master cylinder reservoir often. Do not let it run dry.
Wheel Cylinder Bleeder Screws Torque Specifications
-
Tighten the wheel cylinder bleeder screws.
-
Open the front disc brake caliper bleeder screws one at a time. Leave open until clear, bubble-free brake fluid flows. Be sure to check the brake
fluid level in the brake master cylinder reservoir often. Do not let it run dry.
