F 250 2WD LD Pickup V8-4.6L SOHC VIN 6 (1997)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Hydraulic Assembly
REMOVAL:
-
Disconnect the battery ground cable.
-
Disconnect the two anti-lock brake control module electrical connectors.
-
Disconnect the hydraulic brake tubes.
WARNING:BRAKE FLUID CONTAINS POLYGLYCOL ETHERS AND POLYGLYCOLS. AVOID CONTACT WITH EYES. WASH
HANDS THOROUGHLY AFTER HANDLING. IF BRAKE FLUID CONTACTS EYES, FLUSH EYES WITH RUNNING
WATER FOR 15 MINUTES. GET MEDICAL ATTENTION IF IRRITATION PERSISTS. IF TAKEN INTERNALLY, DRINK
WATER AND INDUCE VOMITING. GET MEDICAL ATTENTION IMMEDIATELY.
CAUTION:Do not allow the brake master cylinder reservoir to run dry during the bleeding operation. Keep the brake master cylinder reservoir filled
with the specified brake fluid. Never reuse the brake fluid that has been drained from the hydraulic system.
CAUTION:Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with
water.
NOTE:Plug each port to prevent brake fluid from spilling.
1
Disconnect the two inlet hydraulic brake tubes.
2
Disconnect the three outlet hydraulic brake tubes.
-
Remove the Electronic Hydraulic Control Unit (EHCU).
1
Remove the EHCU bolts.
2
Remove the EHCU.
