F 250 2WD LD Pickup V8-4.6L SOHC VIN 6 (1997)
5. Remove the front safety belt retractor.
1
Use Safety Belt Bolt Bit T77L-2100-A to remove the bolt.
2
Remove the front safety belt retractor.
6. Use T55 Torx Bit (part of D83L-2100-A) to remove the front safety belt anchor bolt.
INSTALLATION
To install, reverse the removal procedure. Check for proper operation.
NOTE: Make sure that safety belt webbing is not twisted prior to installation.
NOTE: Make sure that after an Automatic Locking Retraction (ALR) retractor is replaced that the retractor is not in the ALR mode of operation
when it is installed.