F 250 2WD LD Pickup V8-4.6L SOHC VIN 6 (1997)
6. Remove the valve body-to-case bolts.
7. Remove the main control valve body.
INSTALLATION
1. Position the main control valve body gasket and main control valve body using the two alignment bolts as a guide.
NOTE: Make sure the manual valve detent lever assembly drive pin engages the manual valve in the proper location prior to installing the bolts.
2. Loosely install the 11 long main control valve body bolts.
NOTE: The main control valve body bolts will be tightened in later steps.
