F 250 2WD LD Pickup V8-4.6L SOHC VIN 6 (1997)
9. Press out the driveshaft yoke bearing cups.
(1) Position the yoke in U-Joint Tool.
(2) Press out the bearing cup.
(3) Rotate the yoke.
(4) Press out the remaining bearing cup.
10. Press out the driveshaft yoke bearing cups.
(1) Position the yoke in U-Joint Tool.
(2) Press out the bearing cup.
(3) Rotate the yoke.
(4) Press out the remaining bearing cup.
ASSEMBLY
1. Install a new bearing cup into the driveshaft yoke.
(1) Start a new bearing cup into the driveshaft yoke.
(2) Position the new spider in the driveshaft yoke.
(3) Position the driveshaft in U-Joint Tool.
(4) Press the bearing cup below the yoke surface.