F 250 2WD LD Pickup V8-5.4L SOHC VIN L (1997)
8. Install the selective direct clutch pressure plate retaining ring.
9. Using a feeler gauge, check the stack-up clearance in three places, 120 degrees apart.
-
If the clearance is not to specification, install the correct selective direct clutch pressure plate retaining ring and recheck the clearance.
10. Install the No. 7 intermediate one-way clutch large thrust washer, aligning the (A) tabs with the (B) notches.
11. Install the bottom end cap.
NOTE: The top and bottom end caps are identical.
12. Install the (A) intermediate one-way clutch over the inner race. Install the (B) top end cap.
NOTE: The (A) lip on the intermediate one-way clutch must face upward.
