F 250 2WD LD Pickup V8-5.4L SOHC VIN L (1997)
9. Using a small drift and mallet, install the new orifice cup plug from Service Kit E9TZ-7H132-B.
NOTE: Make sure the edge of the cup plug is seated just below the stator support surface that mates with the No. 2 needle bearing assembly.
10. If removed, install the front pump seal, using the Front Pump Seal Replacer.
11. Install the (A) No. 1 pump thrust washer and the (B) No. 2A overdrive sun gear thrust bearing.
NOTE:Lightly lubricate the thrust washer and the bearing with petroleum jelly to hold them in place during assembly.
