F 250 2WD Pickup V6-4.2L VIN 2 (1998)
Transmission Mounted Parking Brake Disassembly And Assembly
37. Install the lock nut washer, the lock nut and, using 2 9/1 6-Inch Hex Locknut Wrench T70T4252-D tighten to 288-292 Nm (213-215 lbft).
Transmission Mounted Parking Brake Disassembly And Assembly
38. Use a hammer and punch to dimple the lock nut flange into the notch on the mainshaft.
39. NOTE: The parking brake vent must be clean and open.
Install the parking brake vent. Tighten to 11-16 Nm (8-12 lb-ft).
40. Remove the parking brake from the vise.
41. Install the parking brake on the vehicle.
