F 250 2WD Pickup V6-4.2L VIN 2 (1998)
Air Bag Control Module: Service and Repair
REMOVAL
WARNING: TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE BACKUP POWER SUPPLY MUST
BE DEPLETED BEFORE REPAIRING OR REPLACING ANY AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
COMPONENTS. TO DEPLETE THE BACKUP POWER SUPPLY ENERGY, DISCONNECT THE BATTERY GROUND CABLE AND
WAIT ONE MINUTE. BE SURE TO DISCONNECT AUXILIARY BATTERIES AND POWER SUPPLIES (IF SO EQUIPPED).
CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage can result.
NOTE: The safing sensor is internal to the air bag diagnostic monitor and is not replaced separately.
1. Disconnect the battery ground cable.
2. Remove the RH cowl side trim panel.
3. Remove the air bag diagnostic monitor.
1
Disconnect the electrical connectors.
2
Remove the screws.
3
Remove the air bag diagnostic monitor.
INSTALLATION
1. Follow the removal procedure in reverse order.
Tighten the Air Bag Diagnostic Monitor Screws to 10.2-13.8 N.m (90-122 Lb/In).
