F 250 2WD Pickup V6-4.2L VIN 2 (1998)
Pressure Regulating Solenoid: Service and Repair
REMOVAL
1. Remove the manual control lever.
2. Disconnect the molded lead frame from the sensors.
1
Disconnect the shift solenoid SSA/SS1 and SSB/SS2.
2
Disconnect the Torque Converter Clutch (TCC).
3
Disconnect the Electronic Pressure Control (EPC) solenoid.
4
Disconnect the bulkhead inter connector.
CAUTION: Do not pull on the plastic lead frame. This may cause damage to the connector ends. Carefully pry up on locking tabs to
disconnect the sensors.
3. Remove the EPC solenoid.
INSTALLATION