F 250 2WD Pickup V6-4.2L VIN 2 (1998)
Clutch Slave Cylinder: Service and Repair
REMOVAL
1. Remove the transmission.
2. Remove the clutch slave cylinder.
1
Remove the bolts.
2
Remove the clutch slave cylinder.
NOTE: Inspect the clutch housing for traces of fluid. If fluid is visible, replace the clutch slave cylinder.
3. Remove the clutch release hub and bearing.
1
Push the clutch release hub and bearing against the spring.
2
Remove the retainer ring.
3
Remove the (A) clutch release hub and bearing and (B) spring.
4. Clean the clutch slave cylinder.
5. Inspect the clutch slave cylinder for the following:
-
Weak spring
-
Worn or damaged piston
-
Worn or damaged boot
-
Leaking fluid
6. Wipe oil and dirt off the clutch release hub and bearing.
CAUTION: The clutch release hub and bearing is prelubricated and should not be cleaned with solvent. The clutch release hub and bearing are
replaced as an assembly. Do not disassemble for inspection or replacement.
7. Inspect the clutch release hub and bearing as follows:
