F 250 2WD Pickup V6-4.2L VIN 2 (1998)
7. Install the Gauge Tube.
1
Position the Gauge Tube.
2
Install the differential side bearing caps.
3
Install the four differential side bearing cap bolts.
8. Use a drive pinion bearing adjustment shim as a gauge for shim selection.
^
After the proper shim thickness has been determined, remove the Gauge Tube.
NOTE: Drive pinion bearing adjustment shims must be flat and clean. A slight drag should be felt for correct shim selection. Do not attempt
to force the pinion shim between the Gauge Block and the Gauge Tube. This will minimize selection of a pinion shim thicker than required,
which results in a deep tooth contact in final assembly of integral rear axle assemblies.
9. Use a press and Pinion Bearing Cone Replacer to press the pinion bearing until it is firmly seated on the pinion and pinion shim.
10. Place a new collapsible spacer on the pinion shaft against the pinion stem shoulder.
