F 250 2WD Pickup V6-4.2L VIN 2 (1998)
2. Mark the driveshaft flange and the driveshaft rear axle companion flange for correct alignment during installation.
3. Remove the four rear driveshaft bolts, and disconnect the rear driveshaft.
^
Position the driveshaft out of the way.
4. Remove the pinion nut.
^
Use a suitable companion flange holding tool.
5. Remove the rear axle companion flange, using the 2-Jaw Puller for Differential Case Bearings.
^
Remove the rear axle drive pinion seal.
^
Remove the rear axle drive pinion shaft oil slinger.
