F 250 2WD Pickup V8-351 5.8L VIN H 4-bbl HP (1985)
Oil Pan: Service and Repair
Removal
1. Remove the oil dipstick (on pan entry models only).
2. Remove the bolts attaching the fan shroud to the radiator and position the shroud over the fan.
3. Remove the nuts and lock washers attaching the engine support insulators to the chassis bracket.
4. If equipped with an automatic transmission, disconnect the oil cooler line at the LH side of the radiator.
5. Raise the engine and place wood blocks under the engine supports.
6. Remove muffler inlet pipe.
7. Drain the crankcase.
8. Remove the oil pan attaching bolts and lower the oil pan onto the crossmember.
9. Remove the two bolts attaching the oil pump pickup tube to the oil pump. Remove nut attaching oil pump pickup tube to the number 3 main
bearing cap stud. Lower the pickup tube and screen into the oil pan.
10. Remove the oil pan from the vehicle.
