F 250 2WD Pickup V8-351 5.8L VIN H 4-bbl HP (1985)
Figure 19 - APPLY GREASE TO SEAL LIP
2.
Press a new slinger on the axle shaft with an appropriate piece of press stock. Refer to Figures 17, 18 and 19.
Figure 19 - APPLY GREASE TO SEAL LIP
3.
Install the rubber V-seal on the slinger and axle shaft. The lip of the seal should face towards the spindle. Refer to Figure 19.
Figure 18 - "V" SEAL TO SLINGER INSTALLATION
4.
Install the plastic spacer (3299) on the axle shaft. The chamferred side of the spacer should be inboard against the axle shaft. Refer to Figure 18.
