F 250 2WD Pickup V8-460 7.5L (1983)
Water Pump: Service and Repair
]All water pumps have a sealed bearing integral with the water pump shaft. The bearing requires no lubrication. A bleed hole in the pump
housing allows water that may leak past the seal to be thrown out by the slinger. This is not a lubrication hole. If the pump is damaged and
requires repair, replace it with a new pump or a rebuilt one.
V8-460
1.
Drain cooling system, then remove fan shroud and fan.
2.
On models equipped with power steering, loosen steering pump attaching bolts.
3.
On models equipped with A/C, remove A/C compressor upper bracket, then the idler arm and bracket, compressor drive belt and power steering
pump drive belt (if equipped).
4.
On models equipped with Thermactor, remove Thermactor pump.
5.
On all models, loosen alternator pivot bolt, then remove attaching bolts and spacer.
6.
Remove alternator adjustment arm bolt, pivot bolt and drive belt, then the alternator and bracket as an assembly.
7.
On all models equipped with power steering, remove steering pump attaching bolts and position pump aside.
8.
On all models, disconnect lower radiator hose and heater hose from water pump.
9.
Remove water pump attaching bolts and the water pump.
10.
Reverse procedure to install.
