F 250 2WD Pickup V8-6.9L DSL (1985)
Figure 6
There are two small reinforcement kits. One for 1988 and later models and one for 1987 and prior models. This is necessary because a new hydraulic
clutch master cylinder mounting pattern was introduced for 1988 models.
1987 And Prior Trucks
Use reinforcement kit E3TZ-7K509-A on these trucks, Figure 5. Comprehensive installation instructions are included in this kit.
1988 And Later Trucks
Use reinforcement kit E8TZ-7K509-A on these trucks. The only part in this kit is the special reinforcement for these trucks. To install it, proceed as
follows:
1.
Remove the two clutch master cylinder attaching nuts (13 mm) from inside the truck.
2.
Position the reinforcement in place over the clutch master cylinder studs.
3.
Re-install the two master cylinder nuts, Figure
6.
Tighten to 9.5 - 14.9 N-m.
Large Reinforcement Installation Procedure
Figure 7
Use reinforcement kit E3TZ-7K509-B on all 1983-1991 Bronco/F-Series trucks with hydraulic clutch controls. The kit consists of the following items:
^
A main reinforcement or doubler, with a plate having two studs to clamp the doubler through the cowl inner
^
Two additional pieces with three threaded holes:
