F 250 2WD Pickup V8-6.9L DSL (1985)
1.
Apply a wet, sag-free coat. Allow 3 to 5 minutes flash off.
2.
Apply a second wet, sag-free coat. Allow 3 to 5 minutes flash off.
3.
Apply a third wet, sag-free coat. Allow 3 to 5 minutes flash off.
4.
Apply a final wet, sag-free coat. Allow 3 to 5 minutes flash off. Pull off the "Fine Line" tape, exposing the raw upper edge of the coating.
5.
Immediately clean the spray equipment using Ford Vinyl Paint Precleaner (VC-542-A) or equivalent.
6.
Air drying time depends on the refinishing materials that are used.
^
If you refinish with acrylic lacquer, allow one hour for drying (at 70~F).
^
If you refinish with acrylic enamel, allow two hours for drying (at 70~F).
Color Coat
In order to paint the entire coated area as well as the upper raw edge, mask off the upper margin line using the "Fine Line" tape. Position the tape 1/16"
above the coating edge. The protective coating area can now be finish painted.
NOTE:
IF DAMAGED SHEET METAL EXTENDS ABOVE THE PROTECTIVE COATING AREA, NORMAL PRIME/COLOR PAINT
PROCEDURES SHOULD BE FOLLOWED.
Suggested Equipment
^
DeVilbiss - Spray Gun - Model JGA-502-704-FX or equivalent
^
DeVilbiss - Remote Pressure Cup - Model KB-520 (2 Quarts), Model KB-521 (1 Quart) or equivalent
^
Binks - Spray Gun - Model 62 (# 63 Air Cap, # SS Fluid Tip, # 363 AN Needle)
^
Binks - Attached Pressure Cup - Model 80 (1 Quart, with Air Adjusting Gage) or equivalent.
OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: INFORMATION ONLY
OASIS CODES:
1100, 1800
