F 250 2WD Pickup V8-6.9L DSL (1985)
Suggested Bleeding Proc - Internal Concentric Slave CYL.
Figure 13
If the truck has a concentric slave cylinder, proceed as follows:
1.
Operate the clutch pedal at full stroke, 10-20 times.
2.
Check the fluid level at the change in diameter part of the reservoir. Do not over fill.
3.
Have an assistant depress the clutch pedal slowly and hold it down.
4.
Open the slave cylinder bleed screw and watch for escaping air, Figure 13.
5.
Close the bleed screw and have the assistant release pedal.
6.
Repeat this cycle several times until there is no sign of air. Be sure to keep the reservoir topped to the correct level.
7.
Replace the diaphragm and reservoir cover.
8.
Operate the clutch pedal at full stroke 10-20 times.
Misc. Information
OTHER APPLICABLE ARTICLES: 86-20-10
WARRANTY STATUS:
Eligible Under Basic Warranty Coverage, Powertrain Warranty Coverage
OPERATION DESCRIPTION
TIME
901607A
Inspect & Adjust
0.5 Hr.
901607B
Install Reinforcement
2.9 Hr.
DEALER CODING
BASIC PART NO. CONDITION CODE
7050
50
OASIS CODES:
111000, 505000, 505200, 506000, 590000
