F 250 2WD Pickup V8-6.9L DSL (1985)
Figure 16 - SPINDLE BEARING INSTALLATION
1.
Position a new needle bearing (3123) in the spindle bore of the spindle (3107). The writing on the bearing must face the rear of the spindle. Drive
the bearing into the spindle with the Spindle Bearing Replacer, T80T-4000-R, and Driver Handle, T80T-400-W. Pack the bearing with Long Life
Lubricant (C1AZ-19590-B) ESA-M1C75-B. Install the seal (1175) in the bore against the bearing with the open end of the "V" facing the rear of
the spindle. Refer to Figure 16.
Figure 17 - SLINGER/SEAL/PLASTIC SPACER INSTALLATION
Figure 18 - "V" SEAL TO SLINGER INSTALLATION
