F 250 2WD Pickup V8-7.3L DSL (1990)
1990-97 F-250 HD/F-350/BRONCO - REAR BUMPER
1.
Install newspaper between the tailgate and the bumper top cover to prevent spray on the tailgate.
2.
Hoist vehicle until bumper is at working level.
3.
Clean excessive dirt from inside and outside the bumper.
4.
Spray the back side of the bumper from underneath the vehicle. Make sure to spray the license plate light opening, and the bolt mounting areas
above the bumper mounting bracket to prevent water from leaking to the front from the back side. Also spray the bumper pad retaining holes.
5.
Lower vehicle.
6.
Remove paper and clean off overspray as needed.
1997-98 Expedition - Rear Bumper
1997-98 EXPEDITION - REAR BUMPER
1.
Turn off air suspension, if equipped.
2.
Remove spare tire.
3.
Hoist vehicle until bumper is at working level.
4.
Clean excessive dirt from inside and outside the bumper.
5.
Spray the back of the bumper from underneath the vehicle with Super Seal Anti-Corrosion Compound.
6.
Lower vehicle and turn on air suspension if so equipped.
7.
Reinstall spare tire.
8.
Clean off overspray as needed.
1997 Explorer XLT/Eddie Bauer - Frnt. Bumper
1997 EXPLORER XLT/EDDIE BAUER - FRONT BUMPER
1.
Hoist vehicle until bumper is at working level.
2.
Remove the four (4) screws and two (2) push pins from the lower valance of the radiator and remove valance.
3.
Tape the air intake openings in the bumper (Figure 1). Removal of the license plate bracket is not required.
4.
Clean excessive dirt from inside and outside the bumper.
5.
Spray the edge of the air intake opening and the bumper cover retainer openings with Super Seal Anti-Corrosion Compound.
6.
Remove tape and reinstall the radiator lower valance.
7.
Lower vehicle.
8.
Clean off overspray as needed.
1997 Explorer - Rear Bumper
1997 EXPLORER - REAR BUMPER
1.
Remove spare tire.
2.
Hoist vehicle until bumper is at working level.
3.
Clean excessive dirt from inside and outside the bumper. A light amount will not affect the effectiveness of the Super Seal Anti-Corrosion
Compound.
4.
Spray the back of the bumper with Super Seal Anti-Corrosion Compound paying close attention to the areas around the license plate lights and the
