F 250 2WD Pickup V8-7.3L DSL (1990)
Clearance should be a minimum of .015".
c.
If the clearance is insufficient, replace the knuckle.
NOTE:
CHECK THE CLEARANCE ON THE NEW KNUCKLE BEFORE INSTALLATION.
d.
After measuring the caliper/knuckle for proper clearances, remove both calipers and inner pad assemblies.
e.
Remove the anti-rattle clip from the inner pad.
Figure 2
Figure 3
f.
Reinstall the pad and check the side and end clearances with a feeler gauge. (See Figure 2 for clearance dimensions.)
g.
If the pad clearances are within specification, install the anti-rattle clip on the lower pad tab, Figure 2. Refer to Service Procedure Step 2.
