F 250 2WD Pickup V8-7.3L DSL (1990)
20. Mount a dial indicator between the mainshaft and the case to check end play. Use dial indicator with bracketry Tool-4201-C or equivalent.
21. While rotating the case assembly on the mainshaft to center the bearings. Apply pressure up and down while taking an end play reading. A reading
of 0.0019-0.0039 inches is required. If the reading is not to specification, a thicker or thinner shim must be used.
22. Remove the locknut and the bearing spacer from the shaft.
23. Remove the inner bearing cone and add the necessary additional shims to obtain the specified end play.
24. Reinstall the inner bearing cone on the shaft.
Transmission Mounted Parking Brake Disassembly And Assembly
25. Coat the outer shell of a new inner oil seal with sealer and install it in the bore of the case until it seats inside the bore. The sealing lip of the seal
must face inward.
Transmission Mounted Parking Brake Disassembly And Assembly
26. Install a new O-ring in the notch of the bearing spacer and install both parts onto the mainshaft until the space butts against the shoulder of the
shaft.
Transmission Mounted Parking Brake Disassembly And Assembly
