F 250 2WD Pickup V8-7.3L DSL (1990)
1.
Insert the End Play Checking Tool (T80L-7902-A) or equivalent into the converter pump drive hub until it bottoms, Figures 1 & 2.
2.
Expand the sleeve in the turbine spline by tightening the threaded inner post until the tool is securely locked into the spline.
Figure 3
3.
Attach Dial Indicator (TOOL-4201-C) or equivalent to the tool. Position the indicator button on the converter pump drive hub and set the dial
face at zero, Figure 3.
4.
Lift the tool upward as far as it will go and note the indicator reading. The indicator reading is the total end play which the turbine and stator
share.
5.
Replace the converter unit if the total end play exceeds the limits indicated in the following Converter End Play Specifications Chart.
CONVERTER END PLAY SPECIFICATIONS
NEW OR
TRANSMISSION
REBUILT
USED
AOD
.026
.050" Max.
6.
Loosen the threaded inner post to free the tool and remove the tool from the converter.
CONVERTER REPLACEMENT & OTHER SERVICE REPAIRS
1.
If the thrust washer is worn, the used condition allowable limit of .050" maximum will be exceeded.
2.
If this occurs, replace the converter. Refer to the appropriate Car or Light Truck Shop Manual for service details and the Dealer Master
Parts Catalog for correct parts usage.
3.
To prevent repeat repairs...
^ Perform a thorough flushing of the cooler lines.
^ Replace the transmission filter (E1AZ-7A098-A).
^ Set the TV pressure with a pressure gauge as specified in the Car or Truck Shop Manual.
PART NUMBER
PART NAME
CLASS
E1AZ-7A098-A
Transmission Filter
AG
OTHER APPLICABLE ARTICLES:
None
SUPERSEDES:
91-2-12