F 250 2WD Pickup V8-7.3L DSL (1990)
a.
Disconnect the outer hoses from the steel pipe assembly and slide it away to provide access to the inner (fill) hose clamp.
b.
Disconnect the inner hose from the inner pipe and discard the pinch clamp.
c.
Trim both the inner and the outer hoses by the same amount to achieve desired overall length. Do not allow excessive length that might
cause sink traps to form.
CAUTION:
DO NOT CUT THE INBOARD END OF HOSE BECAUSE IT IS PREMOLDED TO FIT THE TANK.
3.
Reinstall the inner hose on the pipe using a new pinch clamp (N808877-S).
a.
Slide and re-engage the outer hose to the pipe.
b.
Tighten the clamp to 3.2 N-m +/- .5 N-m (28.3 +/- 4.4 lb.in.).
4.
Install the new housing, with pipe and hoses attached, to the body of the vehicle.
a.
Install the other end to the tank.
b.
Tighten the clamp to 3.2 N-m +/- .5 N-m (28.3 +/- 4.4 lb.in.).
CAUTION:
BE SURE THE PROTECTIVE SLEEVE IS POSITIONED OVER THE FRAME RAIL.
5.
Attach the ground wire to the frame crossmember by sliding the clip over the edge of the crossmember with the wire lead pointing down.
Parts Block
OTHER APPLICABLE ARTICLES: 91-17-10
SUPERSEDES: 94-11-17
WARRANTY STATUS:
Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage For 1992-94 Models, Basic Warranty Coverage For All Other Models,
Emissions Warranty Coverage For All Models
OPERATION DESCRIPTION
TIME
941411A
Replace Fill Housing
0.6 Hr.
Assembly, Vapor Vent And
Grommet - One Tank -
Diesel Engine Applications
941411B
Replace Fill Housing
1.2 Hrs.
