ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

A/T - E40D Delayed Initial Engagement|Page 3610 > < Torque Converter - Cleaning and Replacement Guidelines|Page 3605
Page 1
background image

Fluid Line/Hose: All Technical Service Bulletins
A/T - E40D Delayed Initial Engagement

Article No. 
92-1A-3

01/26/92

^

TRANSMISSION - E40D - CONVERTER - EXCESSIVE FLUID DRAINBACK

^

TRANSMISSION - E40D - DELAYED INITIAL ENGAGEMENT

LIGHT TRUCK:

1989-90 BRONCO, E-150, E-250, E-350, F SUPER DUTY, F-150, F-250, F-350

ISSUE:

A delayed initial engagement of 10-20 seconds may be experienced because of converter drainback. This condition is most noticeable in a
vehicle that has been parked for an extended period of time.

ACTION:

Check the drainback (fluid level) on the dipstick and, if necessary, install an in-line check valve in the cooler line going to the rear case
fitting. Refer to the following procedure for service details.

1.

Drive the vehicle for 30-60 minutes to attain normal operating temperature.

Figure 1

2.

Check the transmission fluid level per the instructions in the Owner Guide. Only add fluid if required, Figure 1.

3.

Drive the vehicle through 8 to 10 cycles of 1/2 throttle, 1-2 upshifts to elevate transmission temperature. Then proceed as follows:

^

Park the vehicle on level ground.

^

Allow the vehicle to sit for 30-60 minutes.

^

Check and note fluid level on the dipstick with the engine OFF, in PARK.

4.

Allow the vehicle to sit for a minimum of 24 hours.

A/T - E40D Delayed Initial Engagement|Page 3610 > < Torque Converter - Cleaning and Replacement Guidelines|Page 3605