F 250 2WD Pickup V8-7.3L DSL (1990)
15.
Inspect retaining installation (See Figure 5). If ring is not seated, use opposite face of installation aid to seat ring in groove (See Figure 6). Remove
installation aid from output shaft.
16.
Check to make sure ring is secure (doesn't rotate in groove). If ring rotates, remove and discard it. Repeat steps 11 through 16 to install second
ring provided in kit.
Extension Assembly Installation
1.
Visually inspect parking pawl, pin and spring for proper position (See Figure 7).
2.
Clean the mounting surface on the extension housing and transmission case. Put a new gasket on the new extension housing.
3.
Install the new extension housing and secure it to the case with attaching bolts. Tighten to 20-29 ft.-lb. (30-40 N-m)
4.
Reinstall transmission insulator and retainer assembly to extension housing.
NOTE:
Install the insulator with the word rear to rear of vehicle. Lower transmission.
5.
Remove transmission jack.
6.
Install the insulator and retainer assembly nuts. Tighten to 50-70 ft.-lb. (70-100 N-m).
7.
Attach the speedometer cable and speed-o-gear to the extension housing with the attaching screw. Tighten to 20-25 ft.-lb. (30-35 N-m).
8.
Align marks and reinstall driveshaft into the transmission and secure at the rear axle companion flange with attaching bolts and nuts. Tighten to
