F 250 2WD Pickup V8-7.3L DSL (1990)
Torque Converter: Testing and Inspection
Stator to Turbine Interference - With E4OD
STATOR TO TURBINE INTERFERENCE CHECK
1. Position converter on bench front side down.
2. Install stator support to engage mating splines of stator support shaft
3. Install input shaft, engaging splines with turbine hub.
4. Hold stator shaft stationary and attempt to rotate the turbine with input shaft. The turbine should rotate freely in both directions without any signs
of interference or scraping noise.
5. If interference exists, the stator front thrust washer may be worn, allowing stator to hit the turbine. In such cases, the converter must be replaced.
