F 250 2WD Pickup V8-7.3L DSL (1990)
10.
Cut the nozzle of the Essex Urethane Auto Glass Adhesive U-4OOHV (Figure 1) and apply a triangular bead of urethane 5/8" (16 mm) by 3/8" (9
mm) wide around the perimeter of the pinch weld.
11.
Install the glass into the opening taking care to align the marks previously designated. Press glass into place until full contact is made with
urethane adhesive. Glass must be installed before urethane skins over.
NOTE:
BEFORE INSTALLING GLASS, OPEN THE WINDOWS TO PREVENT THE GLASS FROM BEING PUSHED OUT BY AIR PRESSURE IF A
DOOR IS CLOSED.
12.
If necessary, reinstall all mouldings and trim previously removed.
CAUTION:
WHEN REPLACING URETHANE INSTALLED GLASS, THE VEHICLE SHOULD NOT BE DRIVEN UNTIL THE URETHANE HAS
CURED. THIS WILL PREVENT THE GLASS FROM BEING JARRED OUT OF POSITION AND HELP ENSURE APPROPRIATE
WINDSHIELD RETENTION TO MEET SAFETY AND STRUCTURAL REQUIREMENTS.
NOTE:
USE ONLY URETHANE FOR SERVICE OF AIR AND WATER LEAKS ON URETHANE INSTALLED GLASS.
These products are required for urethane mounted glass replacement:
To locate the nearest distributor of Essex glass replacement products, contact the following locations:
For North America or other:
^ Essex ARG
^ 555 Gaddis Blvd.
^ Dayton, Ohio 45403
^ Phone Within North America: (800) 453-3779
