F 250 2WD Pickup V8-7.3L DSL Turbo VIN F (1994)
Technical Service Bulletin # 95B79
Date: 950101
Campaign - Keyless Entry System Transmitters
95B79
OWNER NOTIFICATION PROGRAM
Remote Keyless Entry System Transmitters - Special "Mail-In" Service Program
Dealer Letter
Attachment I
^
Administrative Information
^
Labor Allowances
^
Parts Ordering Information
Attachment II
^
Technical Information
Customer Notification Letter
Attachment I - Admin./Labor and Parts Information
FCSD Contact
Talk with your FCSD Parts and Service Zone Manager about program concerns.
Claims
Enter claims using DWE. See ACESII Manual, Sections 5 & 6.
Labor Allowances
OPERATION DESCRIPTION
HOURS
OPERATION
Program RKE Transmitters
0.3 Hrs.
B79B
Parts Requirements
There are no parts required for this special owner "mail-in" program.
For owners returning with new transmitters and an authorization letter for a free engine oil and filter change claim for the following allowance:
^ Engine Oil and Filter Change Allowance - $25.00
^ Enter $25.00 in MISC area of the claim as "OTHER" (Includes Labor, Parts and Markup)
Claims Preparation
Enter using DWE.
Use code information shown below:
^
Program Code
- 95B79
^
Labor Operation
- B79B
See Sections 5 & 6 of the ACESII Manual for detailed instructions.
Attachment II - Technical Information
Remote Keyless Entry Transmitter Reprogramming
NOTE:
The reprogramming procedure is basically identical for all vehicles. Exceptions will be identified within each step.
Remote Keyless Entry Transmitter Reprogramming
1.
Locate the 2-pin RKE programming connector. Refer to RKE Programming Connector Location list below.
2.
Turn ignition switch to the RUN position.
3.
Using a jumper wire or alligator clip momentarily short the two terminals within the 2-pin program connector. On Econoline models you will need
to short these terminals for the duration of the reprogramming procedure. The doors will lock then unlock on all models except Contour and