F 250 2WD Pickup V8-7.3L DSL Turbo VIN F (1994)
1.
Support both ends of the bumper. Remove the bumper retaining bolts (one end only) and discard the bolts. (Do not remove the bolts that attach the
bumper to the frame. Only remove the bolts attaching the bumper inner arm to the bumper). See Attachment III.
2.
Remove u-clips from the bumper face bar tabs and discard. If u-clips are broken, remove any portion that may be remaining.
3.
Install new u-clips onto bumper face bar tabs.
4.
Position bumper with locating tab of the inner arm in the hole at the top of the bumper. Install new retaining bolts. Do not tighten bolts at this time.
5.
Perform steps 1 through 4 on the other side of the bumper.
6.
Tighten all bolts to 22.5 +/- 3. 5 N-m (17 +/-2. 5 lb.ft.).
Owner Letter
Serial Number: 12345678901234567 94S79 February 1994
Mr. John Sample
123 Main Street