F 250 2WD Pickup V8-7.3L DSL Turbo VIN F (1994)
Brake Pedal Assy: Service and Repair
With Manual Transmission
REMOVAL
1. Disconnect the wires from the stoplight switch (13480) located below instrument panel (04320).
2. Remove the pin and spacer connecting the brake pedal, stoplight switch and master cylinder push rod together.
3. Remove stoplight switch, master cylinder push rod and brake master cylinder push rod spacer (2B129) from pin on brake pedal. If vehicle is
equipped with speed control, leave speed control bracket in place.
4. Disconnect the clutch pedal retracting spring.
-
Remove the nut on the clutch rod lever.
-
Remove the lever, washer spring, and brake and clutch pedal bushing (2461).
-
Push the clutch pedal (7519) to the side enough for the brake pedal to come off the clutch and brake pedal pivot shaft (7506).
-
Take off the brake and clutch pedal bushings.
NOTE: Some vehicles may have an "E-clip" type retainer instead of a "hair pin clip" type retainer.
ITEM
PART
DESCRIPTION
NUMBER
1
2455
Brake Pedal
2
2005
Power Brake Booster
3
2140
Brake Master Cylinder
4
382802-S2
Nut, 3/8-16 18-34 Nm (13-25 ft lb)
5
N606687-S2
Screw and Washer, M8-1.25 x 16 20-27
Nm (15-20 ft lb)
6
2A309
Brake Master Cylinder Push Rod
Bushing
7
2B129
Brake Master Cylinder Push Rod
Spacer
8
380699-S100
Self-Locking Pin
9
13480
Stoplight Switch
10
--
Y-Brace, Part of Brake Pedal
INSTALLATION