F 250 2WD Pickup V8-7.3L DSL Turbo VIN F (1994)
13
374504
Nut, 3/4-16
14
390622-S
Nut, Retainer 3/4
15
N642569-S36
Cotter Pin, must be installed as
shown
16
1131
Hub Grease Cap
17
2B164
Disc Brake Pad Anti-Rattle Clip
A
2C150
Pins must be installed so that the
retention tabs are touching spindle
surface, not the caliper surface (4
places). Pins may be installed from
either direction.
NOTES
-
Replace brake shoe and lining when the lining is worn to a minimum thickness of 0.794mm (1/32 inch) above the brake backing plate (2211).
-
Always replace all brake shoes and linings on an axle. Never service one wheel (1007) only.
REMOVAL
1. To avoid fluid overflow when the caliper pistons are pressed into the caliper cylinder bores, siphon or dip part of the brake fluid out of the brake
master cylinder reservoir. Discard the removed fluid.
2. Raise the vehicle and install safety stands. Remove the front wheel and tire assembly.
NOTE: Do not use a screwdriver or similar tool to pry wheel cylinder piston away from the front disc brake rotor.
Brake Caliper Compressing Procedure
3. Place an appropriate size C-clamp on the front disc brake caliper with end of clamp against caliper and end of screw against outer shoe. Tighten
the clamp to bottom the caliper pistons in the cylinder bores. Remove the clamp.
4. Clean excess dirt from area around pin tabs.
5. Tap upper caliper pin toward inboard side until pin tabs touch the front wheel spindle.
