F 250 2WD Pickup V8-7.3L DSL Turbo VIN F (1994)
Master Cylinder Installation
4. Remove the nuts retaining power brake booster to brake master cylinder. Remove the brake master cylinder from the power brake booster.
Brake Push Rod Adjustment
INSTALLATION
1. Before installing the brake master cylinder, check the distance from the outer end of the booster assembly push rod, to the front face of the power
brake booster. Turn the push rod adjusting screw in or out as required to obtain the specified length.
2. Position the brake master cylinder assembly over the booster push rod and onto the two studs on the power brake booster.
3. Install the attaching nuts and tighten to specifications.
4. Loosely connect the brake master cylinder outlet rear tube and brake master cylinder connector tube to the brake master cylinder.
