F 250 2WD Pickup V8-7.3L DSL Turbo VIN F (1994)
Technical Instructions
NOTE:
It is imperative that you fully read the following procedures and complete all the steps in the procedure. This procedure includes some inspection and
verification steps in addition to those included in prior TSB's on this subject.
Inspection
1.
Park the vehicle in a flat area. Turn the ignition "OFF".
2.
If the vehicle is a 1992 or 1993 F-Series or Bronco, inspect the release rod and spring for proper position.
The release rod must be fully inserted into the slot in the bracket and the spring must be located behind the slot in the bracket. Refer to Figure 1.
3.
Inspect parking brake control assembly to determine what action is required.
a.
If the parking brake control assembly is of the new cam-in post design. it does not require installation of the wedge. See Figure 2. DO NOT
PROCEED. File form 1864 for inspection only and release the vehicle.