F 250 2WD Pickup V8-7.3L DSL Turbo VIN F (1994)
tightening the power brake booster to the dash.
INSTALLATION
1. Mount the power brake booster on the engine side of the dash panel by sliding the bracket mounting bolts and valve operating rod in through the
holes in the dash.
2. Install the booster mounting bracket-to-dash panel retaining nuts from inside the cab. Tighten nuts to 18-34 Nm (13-25 ft lb).
3. Position the brake master cylinder on the power brake booster, install the retaining nuts, and remove the prop from underneath the brake master
cylinder. Tighten nuts to 18-34 Nm (13-25 ft lb).
4. Install the wrap-around clip on the booster inboard stud.
5. Install the power brake booster check valve. Connect the vacuum booster hose to the power brake booster check valve and secure with the clamp.
Make sure the vacuum booster hose is routed as shown.
6. Install the bushing and position the stoplight switch on the end of the push rod from inside the cab. Then install the stoplight switch and rod on the
pedal pin, along with brake master cylinder push rod spacers on each side, and secure with the cotter pin.
7. Connect the stoplamp switch wiring.
8. Start the engine (6007) and check brake operation.
