F 250 2WD Pickup V8-7.3L DSL Turbo VIN F (1994)
3.
Start engine and observe belt movement. If belt moves too far rearward on tensioner pulley, proceed as follows:
a.
With belt installed, loosen all A/C bracket fasteners. Belt tension will pull A/C bracket inboard towards the engine. (Refer to Figures 3 and 4
for bolt and nut position identification.)
b.
Tighten bolt # 1 on front of cylinder head to 47 N-m (35 lb.ft).
c.
Tighten bolt # 2 on side of cylinder head to 47 N-m (35 lb.ft).
d.
Tighten nuts # 3 (and for 1993 and prior model years, bolts # 4) on side of cylinder block to 62 N-m (46 lb.ft).
4.
Start engine and observe belt movement. If belt moves too far forward on tensioner pulley, proceed as follows:
a.
Remove accessory drive belt and loosen all A/C bracket fasteners.
b.
Pull A/C bracket toward driver's side of vehicle.
c.
Tighten bolt # 1 on front of cylinder head to 47 N-m (35 lb.ft).
d.
Tighten bolt # 2 on side of cylinder head to 47 N-m (35 lb.ft).
e.
Tighten nuts # 3 (and for 1993 and prior model years, bolts # 4) on side of cylinder block to 62 N-m (46 lb.ft).
Parts Block
OTHER APPLICABLE ARTICLES: NONE
SUPERSEDES: 94-9-14
WARRANTY STATUS:
Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage For 1992-94 Models, Basic Warranty Coverage For All Other Models,
Emission Warranty For Belt Loss On Vehicles Equipped With Thermactor Pumps
OPERATION DESCRIPTION
TIME
941019A
Correct Belt Chirp
0.6 Hr.
E-Series
941019B
Correct Belt Chirp
0.5 Hr.
F-Series
941019C
Additional Time To Adjust
0.3 Hr.
A/C Bracket If Gap Is Too
Large - E&F Series
941019D
Correct Belt Squeal -
0.5 Hr.
E-Series
941019E
Correct Belt Squeal -
0.3 Hr.
F-Series
941019F
Correct Belt Edge Wear or
0.6 Hr.
Belt Loss - E-Series
941019G
Correct Belt Edge Wear Or
0.4 Hr.
Belt Loss - F-Series
941019H
Additional Time To Adjust
0.2 Hr.
A/C Bracket To Correct
Belt Tracking - E&F Series