F 250 2WD Pickup V8-7.3L DSL Turbo VIN F (1994)
Oil Pump Assembly
10. Remove inner and outer georotors.
11. Clean oil pump assembly.
12. Inspect inner and outer georotor assembly. Replace the oil pump assembly if any damage is found or if any measurements are not within
specification.
INSTALLATION
Gerotor Installation
1. Install inner georotor on crankshaft.
Gerotor O-ring Installation
2. Install oil pump body plate, outer georotor and oring.
3. Install oil pump body plate bolts (4). Tighten bolts to standard torque specification listed at the end of this section.
NOTE: A new crankshaft front seal (6700) should be installed whenever the crankshaft vibration damper is removed.
NOTE: Apply RTV sealant to the crankshaft keyway prior to crankshaft vibration damper installation.
