F 250 2WD Pickup V8-7.3L DSL Turbo VIN F (1994)
Brake On/Off Switch: Service and Repair
REMOVAL AND INSTALLATION
1. Disconnect battery ground cable.
Fig. 3 Stop Light Switch Replacement
2. Lift locking tab, then disconnect electrical connector from switch.
3. Remove hairpin retainer, then slide stop light switch, pushrod, nylon washers and bushings away from pedal and remove the switch from vehicle.
4. Reverse procedure to install.
NOTE: Ensure stop light switch wires are of sufficient length to allow full travel of the brake pedal.