F 250 2WD Pickup V8-7.3L DSL Turbo VIN F (1994)
Fuel Injector Wiring Harness: Service and Repair
REMOVAL
WARNING: RED-STRIPED WIRE HARNESS CARRIES 115V DC. SEVERE ELECTRICAL SHOCK MAY BE RECEIVED. DO NOT
PIERCE.
CAUTION: Do not pierce engine electrical wires or damage to the harness may occur.
1. Disconnect battery ground cable or cables if applicable to multiple battery vehicles.
NOTE: When the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the Powertrain Control
Module (PCM) relearns its adaptive strategy. The vehicle may need to be driven 10 miles or more to relearn the strategy.
2. Remove valve cover.
3. Disconnect wire connectors from fuel injectors.
Glow Plug Connector Removal
4. Using long needle-nose pliers, remove wire connects from glow plugs. Do not pull on wires when disconnecting glow plug wire connectors.
5. Disconnect wire connector from valve cover gasket using care not to damage valve cover gasket.
6. Remove fuel charging wiring.
INSTALLATION
Follow removal procedures in reverse order.