F 250 2WD Pickup V8-7.3L DSL Turbo VIN F (1994)
Powertrain Control Module: All Technical Service Bulletins
Engine Control - Reduced Power, No Start
Article No.
03-21-3
10/06/03
DRIVEABILITY - REDUCED POWER - NO START - 7.3L
D.I. TURBO - IDM MODULE - NO DIAGNOSTIC
TROUBLE CODES
FORD:
1994-1997 F SUPER DUTY, F-250, F-350
1997 ECONOLINE
Article 95-6-13 is being republished in its entirety as part of a consolidated 7.3L diagnostic aid booklet.
ISSUE
A "no-start" or "reduced power" condition may occur intermittently on some vehicles. This may be caused by a short in the injector circuits or the IDM
module.
ACTION
Follow the diagnostics listed in the Diagnostic Guide and refer to the following Service Procedure.
SERVICE PROCEDURE
1.
If after completion of all the steps in the Power Stroke 7.3L (DI Turbo) Diesel Diagnostic Guide, you are unable to pinpoint the cause of the
concern, proceed with the following steps.
2.
Disconnect the IDM Module connector and using a DVOM, measure the resistance between the injector circuits to ground. If it is less than 5 ohms
resistance, repair the short in the circuit and retest.
3.
If the concern still exists, replace the IDM module.
PARTS BLOCK
OTHER APPLICABLE ARTICLES: NONE
SUPERSEDES: 95-6-13
WARRANTY STATUS: INFORMATION ONLY
Disclaimer