F 250 2WD Pickup V8-7.3L DSL Turbo VIN F (1994)
Seat Belt: Service and Repair
Service Procedures
Post Collision Inspection
WARNING: ALL SAFETY BELT ASSEMBLIES INCLUDING RETRACTORS AND ATTACHING HARDWARE SHOULD BE
INSPECTED AFTER ANY COLLISION. FORD RECOMMENDS THAT ALL SAFETY BELT ASSEMBLIES IN USE DURING A
COLLISION BE REPLACED UNLESS THE COLLISION WAS MINOR AND A QUALIFIED TECHNICIAN FINDS THAT THE BELTS
SHOW NO DAMAGE AND CONTINUE TO OPERATE PROPERLY. SAFETY BELT ASSEMBLIES NOT IN USE DURING A
COLLISION SHOULD ALSO BE INSPECTED AND REPLACED IF EITHER DAMAGE OR IMPROPER OPERATION IS NOTED.
Safety belt assemblies should be periodically inspected to make sure they have not become damaged and are in proper operating condition, particularly if
subjected to severe stress.
Before installing the new safety belt assembly, the safety belt attaching areas must be inspected for damage and distortion. If the attaching points are
damaged and distorted, the sheet metal must be worked back to its original shape and structural integrity.
Install the new safety belt(s) using the appropriate instructions. Perform Functional Test Procedure. See: Testing and Inspection/Functional Test
Rear Outboard
SPECIAL SERVICE TOOL REQUIRED
Seat Belt Bolt Bit # 50 Torx, C771-2100-A
REMOVAL
1. Remove seat shoulder strap guide cover. Remove anchor bolt using Seat Belt Bolt Bit # 50 Torx, T771-2100-A.
2. Remove quarter trim panel.
3. Remove anchor bolt from rear safety belt retractor and tongue and lap bolt using a # 50 Torx bit.
4. Remove damaged or distorted rear safety belt.
INSTALLATION
1. For Installation, follow removal procedures in reverse order.
2. Check sealer around floor anchor bolt holes and, if required, add Ford Caulking Cord D6AZ-19560-A (ESB-M4G32-A).
3. Install and tighten anchor bolts to 30-40 Nm (22-30 ft lbs).
Rear Inboard Center
SPECIAL SERVICE TOOL REQUIRED
Seat Belt Bolt Bit # 50 Torx, C771-2100-A
