F 250 2WD Pickup V8-7.3L DSL Turbo VIN F (1994)
Safing Sensor: Service and Repair
Removal and Installation
WARNING: THE ELECTRICAL CIRCUIT NECESSARY FOR SYSTEM DEPLOYMENT IS POWERED DIRECTLY FROM THE
BATTERY AND BACKUP POWER SUPPLY. TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE
POSITIVE BATTERY CABLE MUST BE DISCONNECTED FOR ONE MINUTE PRIOR TO SERVICING OR REPLACING ANY
SYSTEM COMPONENTS.
NOTE: To service stripped retaining screws, replace old screws with N802455. Tighten to 12.7-13.8 Nm (115-150 in lb).
REMOVAL
1. Disconnect positive battery cable and wait one minute for backup power supply energy to be depleted.
2. Remove RH cowl side panel.
3. Disconnect sensor wiring connector from wiring assembly connector.
4. Remove two screws retaining cowl side panel. Remove sensor.
INSTALLATION
1. Position sensor to cowl side panel.
2. Secure sensor with two retaining screws. Tighten to 7.6-10.4 Nm (62-89 in lb).
3. Connect sensor wiring connector to wiring assembly connector.
4. Install RH cowl side panel.
5. Connect positive battery cable.
NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the powertrain control module
relearns its adaptive strategy. The vehicle may need to be driven 10 miles or more to relearn the strategy.
6. Verify air bag indicator.
