F 250 2WD Pickup V8-7.3L DSL Turbo VIN F (1994)
Power Steering Bleeding: Service and Repair
Verify power steering pump has been properly filled, then start and run engine until it reaches normal operating temperature. Turn steering wheel to the
left and right several times without hitting the stops. Recheck fluid level. If any air bubbles are present, bleed system as follows:
1. Disable ignition by disconnecting coil wire or ICM.
2. Disconnect shutoff solenoid to prevent starting.
3. Crank engine for 30 seconds, check fluid level and add if required.
4. Crank engine for 30 seconds while cycling steering wheel lock to lock. Do not hold steering wheel on its stops.
5. Check fluid level and add fluid if required.
